I left mine for about an hour but that was way too long, so depending on your weather conditions it could vary. This pad was the cleanest in the bunch.Īfter cleaning put it in the sun to dry or use a blow dryer if you want the process to go much quicker. Try as well to keep the shape of the pads intact, they are very delicate and must be massaged not handled roughly.
This process may take between 30 to 45 mins depending on the amount of ink in each pad. Squeeze and press the ink out of the pads under running water until there is no more ink coming out of it. Also its recommended to get some gloves because it will be a very messy operation. Get to a sink or outside with a hose or pipe and an area where the ink can flow without causing a mess. Notice where the power port is to grasp from the image where to find the clip.Īfter removal make a note of the position of the pads in the tray, note that they are not all the same length and shape. Pry the clip downwards and pull it out with flat head screw driver. I will have to remove a screw to the back then place the printer in a position where I can see the clip from below to unhinge the compartment that is holding the pads. Two things need to be done here.ġ) Removal of the ink pads and cleaning them.Ģ) Resetting the ink waste counter via software.įirst I need to access the ink pads which are to the bottom of the printer.
Epson reset printer ink pad full#
This error pertains to the waste ink pads that absorb the extra ink made by the print head being full and the counter that is built into the printer is over the limit amount that could be stored. The customer received the following error “The Printer’s Ink Pads are at the end of Their service life.
0 kommentar(er)
